Haier HWM6815, User Manual

(If there's breakdown, please pull off the power plug before checking) The following

phenomena are not breakdowns sometimes. Please confirm again before sending it to

repair. If there are real breakdowns, please come to the special maintenance department or 

after-sale service department of our company. Do not repair it by yourself.

Phenomena

The reason

How to settle

The top lid is not closed

Is the drain hose put down?
Is the drain hose blocked
by foreign material?

Are the laundries put 
slantingly?

Are the laundries slanting in 
spinning?

Is the machine slanting?

Is the machine slanting?

The water tap is not open

The water inlet valve is blocked

Is there power failure?

Is the power plug loose?

Is the jointer screw of the water
inlet hose is loose or twisted
awry?

The water faucet leaks

There's abnormal sound
inside the machine

The machine
does not act

Close the top lid

Put down the drain hose.
Open and close the top lid once.
Clean the foreign material.
Open and close the top lid once.

Re-order the laundries. Close the
top lid.
Level the machine in right position.
Open and close the top lid once.

Open the water tap. Push the
 "Start/Pause" button.
Clean the water inlet valve.
push the "Start/Pause" button.
Wait for the normal water pre-
ssure before use.

Use it when the power is on.

Insert the power plug tightly.

Level the machine properly.

Re-order the laundries.

Fasten the jointer screw
properly.

Trouble shooting

Answer to question

Does the water level arrive at the 
set water level?

Affusion to the set water level.

Is the power plug loose?

Insert the power plug tightly.

Is the top lid closed?

Close the top lid

Are the laundries put orderly?

Put the laundries orderly.

Not spin

Not wash

Buzzing upon reservation starts,
Nixie tube indicates "E0"

Safety switch actuates, not spin,
 (after self-correction twice),
nixie tube displays  "E3", buzzing

No or slow water filling

not

reaching the level in 15min

,

nixie tube indicates "E4",
buzzing

No or slow drain, nixie tube

indicates "E1" , buzzing.

If the nozzle is choked with
foreign bodies

Remove the foreign bodies

Poor or no waterfall flow

The top cover leaves open

Close the top lid

Running pauses during spin,

nixie tube indicates "E2",

buzzing

It is the water remained in the factory inspection of
performance.

Common phenomena

Phenomena                                                  Explanation

Balance the laundries to avoid slanting.

The program is setting the drain time. Some time is
 needed before it starts spinning.

To prevent splash during water filling.

The spinning is intermittent when it starts.

While water filling in wash and rinse, the 
pulsator pauses rotation 

There may be some water flowing out of 
the drain hose in the first use of the machine.

Push the "P

rocess

" button to 

select "Spin", but it doesn't work.

Supplementary water filling 48 s after
 sensor tests cloth material.

Wash pauses 

The water pressure is too low
and  the current is too small

15