Haier HWM6815, User Manual

How to change the direction of the drain hose

1.

The height of the drain hose shall be 

   less than 10cm, or the drainage will not
   be smooth, and cost such long time that
   the machine may stop at mid way.

2.

Do not trample or press the drain hose.

If the drain hose is too long, cut it at mid 

    point. To make smooth drainage, cut the 
    front end of the hose slantingly.

4.

If extra drain hose is needed, please 

   make separate purchase. The inner 
   diameter of the extra hose shall not 
   less than 30mm, and the length shall 
   not exceed 1.5m.

5.If the extra hose is too long, cut it
either at A or at B point.

<10cm

Usage of the drain hose

The drain hose shall drain smoothly

5

1.

Loosen the fastening screw of the

back cover to take off the back cover.
Be careful not to do it by force to
prevent breaking the claw of the back
cover.(as indicated in Figure 1)

3.

Extend the drain hose from the installation

 hole at the right side of the base frame. Fix 
 the drain hose onto the base frame with the 
 drain hose frame and fasten the screw. Then
 set the drain hose hook on the drain hose and
 hang the drain hose on the hanging hole of
 the cabinet. (As
indicated in Figure 3)

4.

To install the back cover, first hang the lower

 beard of the back cover on the cabinet, then
 push the claws at the two side and the upper
 end from bottom to top to resume the original
 setting. Be careful not to do
 it by force. Then fasten
 the screw (two points)
 (as indicated in Figure 4).

2.

Take off the drain hose from the cabinet.

 Nip the drain hose  outlet slightly.
 Dismantle the drain hose hook. Loosen
 the fixing screw of the drain hose frame
 to dismantle the drain hose frame. Pull
 the drain hose into the cabinet from the
 left side of the base frame.

Drain hose frame

Nip the drain hose outlet
and take off the drain hose hook

Screw

Figure 3

Back cover

Figure 1

Screw

Top claw

Claws at the
two sides

Lower bread

Figure 4

Figure 2