Operation and Wash Cycles
16
The amount of detergent for a given cycle can be adjusted to the following levels 1, 2, 3, 4,
5, and Hi. Turn the dial to the selected wash cycle you want to adjust the Auto Dose level.
Hold down the Wash + button for 3 seconds, the screen wiill then display SEt.
Rotate the dial clockwise to increase the detergent level up to Hi, or rotate
counterclockwise to reduce level down to 1.
To store the new detergent level setting press "Wash+" for 3 seconds,
the screen will flash SEt.
NOTE:
The Auto Dose function only applies to HWT10AD1, HWT10ADB1 1 and HWT12AD1,
but not HWT09AD1.
When‘’is selected,‘Wash’,‘Rinse’and‘Spin’is the default for the
‘Advance Wash’modifier. The cycle will start the wash by flash ing the‘Wash’LED
continuously. When the cycle progresses to the short soak phase the‘Soak’LED will
flash continuously ,while the‘Wash’,‘Rinse’and‘Spin’LEDs are solid. At the
completion of the soak phase when the machine resumes the wash the‘Soak’LED
will go out , and the‘Wash’LED will flash continuously.
The wash will continue to progress flashing the LED of the current cycle stage.
As it progressed it turns off the LED when the stage has completed.
Wash operation sequence: This parameter is applicable only to HWT10AD1,HWT10ADB1
and HWT12AD1.
When the Smart Dose detergent tray is almost out of detergent the display will flash FILL
on the screen. The tank will need re-filling before another Auto Dose cycle is run.
