Installation & Adjustment
Drain hose
5
Drain hose
clamp
Drain hose joint
1. The height of the standpipe or washbasin should be
between 0.8 - 1.2 m.
Bracket
0
.
8m h
1
.
2m
1. Remove the cap of the drain hose outlet.
Note: A small amount of water may come out when the cap is removed. This is
normal as there may be some water left in the pump from
when the machine was tested during manufacture.
60mm
20mm
Installation on an uneven surface can lead to“
out of balance
”events, instability in the
machine operation, or even failure to successfully complete a wash cycle.
Please refer to the following steps for adjustment:
1. Confirm whether the machine is level.
2. Lift the lid and ensure that the bowl is central to the top deck opening.
Adjust the two front leveling feet as necessary.
Balanc
ing the
washing machine
NOTE:
：
Not level
level
and the washing machine's rear end should be at
least 60mm away from the wall.
2. First, connect the drain hose to the connection point on
the lower right side of the cabinet, and fasten with drain hose
clamp (provided).
3. Connect the drain hose guide onto the outside of the drain hose
To guide the drain hose over the washbasin or standpipe,
the bracket must be fitted to the drain hose.
2. To avoid siphoning, the drain hose should not
extended that more than 20 mm from the end of
the guide.
Ensure the drain hose is held in place to avoid
leakage or spills.
CAUTION: The drain hose is subject to water pressure in use and may come loose
from the installed connection point. Secure the drain hose against
unintentional loosening.
The washing machine requires at least a 20mm
clearance to a side wall or other adjacent product,
