12
Maintenance
•In order to prevent an electric shock or casualties, please make sure to cut off the
power of the Transport cooler before conducting any repair to the Transport cooler.
•Make sure not to inhale medicine or suspended particles around the storage box
when maintaining the Transport cooler. Otherwise, there may be health risk.
1.Clean transport cooler
•Clean the Transport cooler once a month. Regular cleaning can keep a completely new
appearance of the Transport cooler.
•Use a piece of dry cloth to wipe off the small amount of dust accumulated on the Transport cooler's
housing and inner chamber and all the accessories as well. If the Transport cooler is very dirty, use
a piece of cloth dipped with mild detergent to clean off the dirt, then use a piece of wet cloth to wipe
the residual detergent, and wipe it with a dry piece of cloth.
•Do not pour water onto the Transport cooler enclosure or into the Transport cooler. Otherwise,
damage to electrical insulation may result in faults.
•The compressor and other machinery parts are in completely sealed state, so there is no need to
lubricate them.
2.Stop using Transport cooler
•Power off the Transport cooler if it will be out of service for a long time.
•Open the door of the Transport cooler and thoroughly clean the Transport cooler.
•After the Transport cooler is aired, close the door of the box and put the plastic bag on it for sealing
storage.
Warning
5
Product installation
•Environmental temperature: 10 to 28
℃
. Air conditioning system shall be used when necessary.
•Ambient humidity: below 85% RH.
•Avoid large quantities of dust.
•Avoid mechanical sway or vibration.
•The altitude of Transport cooler's working position: lower than 2000m.
•Input voltage: supports 12V and 220V switching.
For normal operation and optimum performance level of the Transport cooler, its installation place
shall
conform to the following conditions:
•It cannot be installed in a narrow, small, and airtight space. It shall at least be guaranteed that the
product can be moved in/out normally so as to avoid any maintenance difficulty and failure. The
failure of in-time repair may cause damage to the stored articles.
•The ground at the installation place shall be solid and flat.
•The place shall be well-ventilated without exposure to direct sunshine.
•Do not share a socket with other equipment, the plug and socket shall be firmly connected.
•Do not distort nor stress the power cord.
•If it is required to lengthen the power cord, the section area of the lengthened wire shall not be less
than 2mm
2
and the length shall not be longer than 3m.
•Check the operating voltage before use and consider to use manostat suitable for the electromotor
load to stabilize the voltage at areas where the voltage is not stable.
•It shall be guaranteed that the Transport cooler is reliably grounded.
•If the power socket has grounding wire, check if the grounding connection is good before use.
•If the socket is not equipped with a grounding wire, make sure that it will be installed by the
professional engineering technical personnel.
•It shall be away from the radiated area. Avoid the use of radiation-sensitive devices at its periphery.
•As the Transport cooler is sensitive to the environmental temperature, the Transport
cooler cannot operate normally if it is installed in an environment other than the above-
mentioned environment.Please use it after improving the environment.
•It is prohibited to install the Transport cooler in an open-air environment.When the
Transport cooler gets wet in the rainwater, leakage of electricity or electric shock
accidents may possibly be caused.
•Do not ground the Transport cooler via gas piping, water supply pipe, telephone line or
lightning rod, which may easily cause an electric shock.
•After installation, the power plug must be accessible to pulling the plug conveniently in
emergency.No articles shall block out the air vent of the Transport cooler.
Installation environment
Caution
Installation place
Warning
