EN
10-Troubleshooting
23
Troubleshooting without display-codes
Problem
Possible cause
Possible solution
Tumble dryer
fails to operate.
•
Poor connection to the power
supply.
•
Power failure.
•
No drying program is set.
•
Device has not been switched
on.
•
The water tank is full.
•
The door is not closed properly.
•
Check connection to the pow-
er supply.
•
Check the power supply.
•
Set a drying program.
•
Switch the device on.
•
Empty the water tank.
•
Close the door properly.
Tumble dryer
fails to operate
and the display
shows
.
•
The laundry has reached the
dry level defi ned by the pro-
gramme?
•
There is no laundry in the drum?
•
Check if the program setting
is appropriate.
•
Check if there is laundry in the
drum.
Drying time is
too long and
the results are
not satisfactory
•
The programme setting is not
correct.
• The fi lter is clogged.
•
The evaporator is blocked.
•
The tumble dryer is overloaded.
•
The laundry is too wet.
•
The vent duct is blocked.
•
Make sure the program is set
correctly.
• Clean the fi lter screen.
•
Clean the evaporator.
•
Reduce the amount of laun-
dry.
•
Spin the laundry properly be-
fore drying.
•
Check the vent duct and unblock
it.
Remaining time-
on the display-
stops or skips.
The remaining time will be adjus-
ted continuously based upon the
following factors:
•
Type of laundy.
• Loaded amount.
•
Moisture degree of the laundry.
• Ambient temperature.
The automatic adjustment is a
normal operation.