Haier JQ-F160A, User Manual

1. Remove all packaging material. This includes the foam base and all

adhesive tape holding the wine cellar accessories inside and outside.

2. Inspect and remove any remains of packing, tape or printed

materials before powering on the wine cellar.

• Your wine cellar has three leveling legs which are located in the

front and rear corners of your wine cellar. After properly placing your
wine cellar in its final position, you can level your wine cellar.

• Leveling legs can be adjusted by turning them clockwise to raise your

wine cellar or by turning them counterclockwise to lower your wine
cellar. The wine cellar door will close easier when the leveling legs are
extended.

• After leveling legs are adjusted, the door support also needs to be

adjusted to floor level.

• To assure your wine cellar works at the maximum efficiency it was

designed for, you should install it in a location where there is proper air
circulation, plumbing and electrical connections.

• The following are recommended clearances around the wine cellar:

Sides……………2" (50mm)
Top....................2" (50mm)
Back..................2" (50mm)

• Do not over fill your wine cellar for proper wine cooling.

Note:

If your wine cellar has been tilted for any reason, wait 24 hours
before plugging it in.

Installing Your Wine Cellar

Unpacking Your Wine Cellar

Proper Air Circulation

Leveling Your Wine Cellar

English

English

5