Haier LC-2710D, Operating Instructions Manual

7

PREPARATION FOR REMOTE CONTROL

3

2

1

+

+

Remote control installation

1. According to the figure display below, place the remote control with face down,  
    then open the cover of  battery apartment. 
2. As in the figure display below, install two AA batteries. (The + and - symbol of 
    battery must match with the marks on the remote).
3.Close the cover of battery apartment.

Cautions for using remote control
Confirm there is no object between the
remote control and the remote sensor
of TV set.

Sunshine or other strong light will 
interfere the signal sent by the remote
control. In this situation turn the TV
set to avoid the direct light source.

Do not put the remote control in direct
heat or a damp place, or potential 
damage to the remote may occur.

Please use two AA  1.5V batteries.
Do not mix battery types.
Install the batteries as the correct 
polarities.
Do not use the rechargeable batteries.

6

BASE DISASSEMBLY METHOD AND PREPARATION FOR WALL MOUNT BRACKET

(1) In order not to scratch the TV set, it is recommended putting the TV set 
      with the face down on the soft and clean blanket.
(2)Disassemble the six screws from base and remove the base.
(3)Mount the airproof board  as figure.
(4)Take out the switching support from accessory bag,  and use four M5

×

16 

     screws(included in the accessory bag) to fix the switching support on the 
     back of complete set.

Note
1. The arrow indicates the position of screw.
2. The remaining four M5

×

16 screws in the accessory bag are used to mount the 

     wall mount parts.(replace the four M4

×

20 screws in the packing carton of wall

     mount bracket.)
3. This operation is only used before mounting the bracket.
4. Wall mount bracket is sold separately.

Base 

Switching support

Switching support

Airproof board