Service Manual
Model No:
Issue
Rev.
20
Service Manual
6-2-6 No spinning
6-2-7 Too much spinning noise
The washing and
draining are normal.
Replace the drain motor.
Replace the hanger.
Replace the motor.
Fasten the motor.
Replace the retarder.
Adjust the angle or the distance of
the ratchet and pawl. The distance
between the ratchet and the pawl is
above 2mm.
Adjust the cabinet to acquire
balance.
Adjust the gap between the
balance ring and the outer tub.
Fix the connecting pipe and
wire unit.
Replace the retarder clutch.
Check the On/off point of the
microswitch and stop switch.
At this time please check
if the drain motor is well.
No On/Off point
Replace the microswitch
or stop switch.
Normally
Check if the clutch pawl
is pulled enough.
If the washing machine
is set horizontally?
If the noise of the motor
is too much?
If the motor is fastened
tightly?
If the bearing of the retarder
is well?
If the departing of
the ratchet and pawl
is well?
If the machine body
vibrate resonantly with th
cabinet?
If the balance ring is rubbing
the outer tub cover?
If the connecting pipe
or the wire unit bumps
the outer tub?
The hanger seat is lack of oil.
Inject oil at the hanger seat.
If the hanger is
wrongly used?
No
No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
No
No
No
No
No
No
No
No
Yes
Yes
Yes
Set the machine horizontally
520-MABE1789
