17
Service Manual
Model No:IDW12P-E/IDW12P-U
Issue
Rev.
3
.
If so, rest the bottom edge of the panel on the base moulding and mark the part to be cut. Leave
at least 3
mm of the play between the panel and the base moulding to allow for the door to rotate freely
(Fig.11)
4
.
Remove the base moulding and trim it as needed, protecting the surface that has been cut with
a paint or
5
.
Install the base moulding again (Fig.12).
How to use water-proof plastic
Firstly take off the water-proof plastic from the sticker with the appliance (see
_
I=Fig.13). Secondly
stick it on the bottom of the kitchen board (see
_
I=Fig.13). All of this can avoid humidity in the
kitchen.
Positioning the Unit within the Cutout (Fig.14)
Push the dishwasher into the cutout opening and turn the feet to make it level and to adjust for
height so that the crosspiece (A) for fastening it in place located on the top part of the machine
(Fig.14) comes into contact with the counter .Align the door panel mounted on the dishwasher
with the doors on the adjacent cabinet (2).
Important:
The dishwasher must absolutely be fastened to the counter top to prevent the machine from
tipping when the loaded dish racks are pulled out.
Adjustment of Back Feet (Fig.10A)
Insert the appliance in the cutout and then adjust the height of the machine using the screws
located at the bottom front .Use a screwdriver to turn the screws in a clockwise direction to raise
the dishwasher and in an anticlockwise direction lower it.
Notice:
If power screwdrivers are used to make the adjustment, make the final adjustment manually with
a normalscrewdriver.
Fig.11
Fig.12
Fig.13
Fig.14
