20
Service Manual
Model No:IDW12P-E/IDW12P-U
Issue
Rev.
7. How to fill the rinse aid dispenser
7-1.Rinse aid
T
his product makes dishes sparkle and helps them to dry without spotting. The dispenser is
located on the inside panel of the door .
7-2.Loading the rinse aid
Regardless of the type of detergent dispenser installed on
your appliance, you must proceed as indicated below when
loading the rinse aid.
To open the dispenser, turn the "
1
" cap in an anti-clockwise
direction and then pour in the rinse aid, making sure not to
overfill. The amount of rinse aid used for each cycle can be
regulated by turning the "
2
" dose adjuster, located beneath
the "
1
" cap, with a screwdriver.
There are 6 different settings; the normal dosage setting is
3.
Important
Proper dosage of the rinse aid improves drying.
If drops of water remain on the dishes or spotting occurs, the dosage adjuster
should be turned to a higher setting.
If the dishes have white streaks, turn the dosage adjuster to a lower setting.
7-3. Detergent
D
etergent specifically intended for use with dishwashers
must be used. The dispenser must be refilled before the start
of each wash cycle following the instructions provided in the
"Programme overview". The detergent dispenser is located
on the inside panel of the door.
7.4.Loading the detergent
●
T
o open the "
3
"
cover on the dispenser, press the "
4
"
button.
●
The detergent for the wash cycle should be poured into
the "
5
"
compartment.
●
The detergent for the pre-wash cycle should be poured
into the “
6
”
compartment.
●
After the detergent has been placed in the dispenser,
close the cover and press down until it clicks in place.
Notice:
To facilitate closing the cover, remove any excess of detergent on the edges of the
dispenser.
1
2
5
6
4
3
