Haier QAS740, User Manual

49-88074-1

17

ENGLISH

GLASS COOKTOP

Normal Daily Use Cleaning

ONLY use CERAMA BRYTE® Ceramic Cooktop Cleaner on 
the glass cooktop. Other creams may not be as effective.

To maintain and protect the surface of your glass cooktop, 
follow these steps:

1.  Before using the cooktop for the first time, clean it with 

CERAMA BRYTE® Ceramic Cooktop Cleaner. This helps 
protect the top and makes cleanup easier.

2.  Before using the cooktop for the first time, clean it with 

CERAMA BRYTE® Ceramic Cooktop Cleaner. This helps 
protect the top and makes cleanup easier.

3.  Shake the cleaning cream well. Apply a few drops of 

CERAMA BRYTE® Ceramic Cooktop Cleaner directly to 
the cooktop.

4.  Use a paper towel or 

CERAMA BRYTE® Cleaning 
Pad for Ceramic Cooktops 
to clean the entire cooktop 
surface.

5.  Use a dry cloth or paper 

towel to remove all cleaning 
residue. No need to rinse.

NOTE: It is very important that 
you DO NOT heat the cooktop 
until it has been cleaned 
thoroughly.

Burned-On Residue

NOTE: DAMAGE to your glass surface may occur if you use 
scrub pads other than those recommended.

1.  Allow the cooktop to cool.

2.  Spread a few drops of CERAMA BRYTE® Ceramic 

Cooktop Cleaner on the entire burned residue area.

3.  Using the included CERAMA BRYTE® Cleaning Pad 

for Ceramic Cooktops, rub the residue area, applying 
pressure as needed.

4.  If any residue remains, repeat the steps listed above as 

needed.

5.  For additional protection, after all residue has been 

removed, polish the entire surface with CERAMA 
BRYTE® Ceramic Cooktop Cleaner and a paper towel.

Heavy, Burned-On Residue

1.  Allow the cooktop to cool.

2.  Use a single-edge razor blade scraper at approximately a 

45° angle against the glass surface and scrape the soil. It 
will be necessary to apply pressure to the razor scraper 
in order to remove the residue.

3.  After scraping with the razor scraper, spread a few drops 

of CERAMA BRYTE® Ceramic Cooktop Cleaner on the 
entire burned residue area. Use the CERAMA BRYTE® 
Cleaning Pad to remove any remaining residue.

4.  For additional protection, after all residue has been 

removed, polish the entire surface with CERAMA 
BRYTE® Ceramic Cooktop Cleaner and a paper towel.

Metal Marks and Scratches

1.  Be careful not to slide pots and pans across your cooktop. 

It will leave metal markings on the cooktop surface.

 These marks are removable using the CERAMA BRYTE® 
Ceramic Cooktop Cleaner with the CERAMA BRYTE® 
Cleaning Pad for Ceramic Cooktops.

2.   If pots with a thin overlay of aluminum or copper 

are allowed to boil dry, the overlay may leave black 
discoloration on the cooktop.

This should be removed immediately before heating 
again or the discoloration may be permanent.

NOTE: Carefully check the bottom of pans for roughness 
that would scratch the cooktop.

CARE AND CLEANING

Clean your cooktop after each 

spill. Use CERAMA BRYTE

®

Ceramic Cooktop Cleaner.

ÞöèäÌÎÛÊÖÊËÛâÝÎ

®

 Cleaning Pad for Ceramic Cooktops.

ÝëèÌÎÛÊÖÊËÛâÝÎ

®

 Ceramic Cooktop Scraper and all 

recommended supplies are available through our Parts Center. 

See instructions under “To Order Parts” section on next page.

NOTE: Do not use a dull or nicked blade.