Haier WJ01X24721, Owner'S Manual

8

49-5000786   Rev. 0

ENGLISH  

Cleaning the Air Inlet Grille and Air Filter

Turn off the power supply

Do not touch with wet hand

Do not use hot water or industrial cleaner

Air filter washing

NOTE: Do not forcibly pull down the air filter, it can damage it. 
If the environment where the unit is located is full of dust, it is 
recommended that the air filter be washed at least twice a week.
1.   Remove the air inlet grille: 

–  Press the 2 buttons down on the grille and slide it towards 

the direction of the arrows as shown in Fig. 1

     –  Raise the grille up at a 45

°

 angle to remove the air inlet 

grille.

2.  Remove the air filter (Fig. 2) : 

– Press the outer edge of the air inlet grille with your thumb. 
At the same time, pull out the bottom edge of the filter net 
with your forefinger, so the filter net comes apart from the 
buttons. Remove the net. 

Clean the air inlet grille

1.  Open the air inlet grille: 

–  Pull the two handles at the same 

time. Slowly pull them out. When 
closing it, do this in reverse.

2.  Remove the air filter: 

– Refer to "Air filter washing".

3.  Clean the grille: 

–  Use a soft brush, water and a neutral detergent to clean, 

then rinse the grille throughly.

NOTE: Do not use hot water over 122

°

 F 

(50

°

C) to clean the grille. This will cause 

discoloration or deformation. When 
there is too much dust in the area, use a 
ventilation fan or directly spray the detergent on the air inlet 
grille. Wait 10 minutes and rinse with water.

4.  Install air inlet grille: 

– Refer to # 3.

5.  Install the air filter: 

– Refer to "Clean the air filter".

6.  Close air inlet grille: 

– Refer to # 1.

Figure 2

The bottom edge 
of the filter net

The edge of the air 
inlet grille

NOTE: The above images are only representations. Please 
refer to your grille for an accurate reference.

OPEN

Figure 1

Press buttons in the 
direction of arrows.

Raise up grille to 

remove

OPERATION AND MAINTENANCE