3
2.1 Drill Holes
2.1.1 Measure up approximately 36”from the door bottom.
Apply template to the door edge. Mark center of door edge
as indicated on template.
2.1.2 Mark center hole on door face through guide on
template for 2-3/8”(60mm) or 2-3/4”(70mm) basket.
2.1.3 Drill 2”or 2-1/8”hole through door face as marked for
lockset. It is recommended that holes be drilled from both
sides to prevent splitting.
2.1.4 Drill 31/32”or 1” hole in center of door edge for latch.
Check template for correct size for your latch application.
2.2 Install Latch And Strike Plate
2.2.1 Insert latch in the hole keeping it parallel to face of door.
Mark outline and remove latch.
2.2.2 Chisel 1/8”deep or until latch face is flush with door edge.
2.2.3 Insert latch with the beveled edge of the latch facing the
door frame and tighten screws.
2.2.4 Install strike plate on door jamb accordingly.
2.3 Install Front Plate
2.3.1 Fix one connecting screw tube on the front plate.
2.3.2 Place water proof rubber under the front plate.
2.3.3 Install front plate to door, pull the data line through door
hole.
