Page 18
WARNING
Observe the risk of trapping when opening/closing the lid using the foot pedal. Before starting the process of
opening and closing, check there is nobody near to the lid as trapping may have serious consequences.
Always operate the lid with caution.
Pinch protection
If something with sufficient resistance prevents the lid from closing then pinch protection is activated.
If an object is detected that would interfere with the lid closing, the lid stops and then reverses to the fully open
position (if able to do so). An audible warning is given to indicate the reopening of the lid. Remove any
obstructions and if the lid is open, press the foot pedal again to close the lid.
To stop the lid closing
This can be done by pressing the foot pedal. The lids movement is interrupted and it then reverses to the fully
open position (if able to do so).
CAUTION
Do not attempt to manually close or open the lid when stationary or during automatic operation; this may cause
damage to the hinge or latch actuators. In the event of this happening an audible warning may sound.
Operating advice
•
Activate Quattro immediately after every load; do not leave the lid open.
•
Wash hands after every load.
•
Never use a chemical reaction substance to clear a drain block situation in the disposer as damage to the
seals will occur.
•
To reduce the possibility of the machine jamming, do not place the bedpans inside each other when placing
them in the hopper.
•
If electrical power to the machine fails during an operation cycle, the interlock remains engaged. The
interlock releases once power is restored to the machine.
•
Do not attempt to force the lid open or shut.
Daily maintenance
•
Run the machine under
‘no load’ conditions to clear any residue.
Summary of Contents for Quattro Vanguard Enhanced
