Page 8
User Information acc. to FCC15.21
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
Statement acc. RSS GEN Issue 5
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference
(2) This device must accept any interference, including interference that may cause undesired operation of the
device..
Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes aux RSS (RSS) d'Innovation,
Sciences et Développement économique Canada. Le fonctionnement est soumis aux deux conditions
suivantes:(1) Cet appareil ne doit pas causer d'interférences(2) Cet appareil doit accepter toutes les
interférences, y compris celles susceptibles de provoquer un fonctionnement indésirable de l'appareil..
Electrical safety
•
Low voltage electrical equipment (less than 1000V) can cause serious or fatal injuries.
•
Any person installing or maintaining this equipment should be fully competent to carry out this work.
•
Such persons should be familiar with the relevant codes of practice or standards which are applicable to the
country of installation.
Preliminary operating advice
•
All instructions located directly on this machine must be observed and be kept completely legible at all
times.
•
This machine is designed to operate on a fully automatic cycle. During this cycle it will only stop if a fault
occurs or if it is overloaded.
•
If the hopper is overloaded beyond the recommended capacity the internal trip can cause the machine to
stop. Continued abuse in this manner will eventually cause motor failure.
•
If an emergency occurs, such as a foreign object being in the hopper, the machine should be stopped
immediately by switching off the power at the isolator.
Staff qualifications and training
•
All staff who operate, maintain, inspect or install the machine must be suitably trained and qualified and
have the necessary equipment or tools to carry out their tasks safely.
•
The person who is responsible for staff supervision should define the exact areas of responsibility and
scope of authority for all staff using or maintaining the machine. If a member of staff lacks the necessary
knowledge, he or she must receive due training and instruction.
•
Any training or instruction required can be provided by the manufacturer or supplier.
•
The supervisor must also make sure that the content of this manual is fully understood by the staff
concerned.
Summary of Contents for Quattro Vanguard Original
