Operation
Information brochure · H-50.2 system components
V02R00 · 1134319 · 2022-11
41
6.5
Entry and exit points of the fall-arrest system
1
End stop at the entry and exit points
WARNING!
Danger of falling due to the fall arrester sliding out of the fall protection rails
Each position on the fall-arrest system at which the fall arrester can unintentionally slide out of
the fall protection rail must be secured using an end stop.
All entry and exit points must be accessible from a safe position; if necessary, the user must be
secured to prevent falling either collectively or by means of a securing system!
Upon entry and exit from the fall-arrest system, secure yourself to an approved attachment point
(in accordance with EN 795).
There are entry and exit points at the beginning and end of the access route, as well as at the
platforms along the fall-arrest system in accordance with local circumstances.
The Hailo PARTNER H-50.2 fall arrester is used to enter and exit the fall-arrest system directly at
the fall protection rail.
There is an end stop [1] at the entry and exit points at the beginning and end of the access route.
The end stops prevent the fall arrester from unintentionally sliding out of the fall protection rail.
Additional shock absorbers: e.g. when exiting the H-50.2 fall-arrest system
The lengths of the connections to additional safety systems must be kept as short as possible
to limit the fall height accordingly in the event of a fall.
Additional shock absorbers, e.g. Y-connectors, may only be secured to the intended attach-
ment points (in accordance with EN 795).
