Hailo Libero 2.0, Installation Instruction

Libero 2.0

13

Regulatory Information USA

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device 
must accept any interference received, including interference that may cause undesired operation.
Class B device notice

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide 
reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed 
and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a 
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the 
user is encouraged to try to correct the interference by one or more of the following measures:
  -  Reorient or relocate the receiving antenna.
  -  Increase the separation between the equipment and receiver.
  -  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  -  Consult the dealer or an experienced radio/TV technician for help.
RF exposure safety
This device is a radio transmitter and receiver.

It is designed not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission.

The antenna must be installed and operated with minimum distance of 20 cm between the radiator and your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Regulatory Information Canada

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Les changements ou modifications non expressément approuvés par la partie responsable de la conformité pourraient annuler l‘autorisation de l‘utilisateur d‘utiliser l‘équipe-
ment.

This device complies with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device 
may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR de l’ISDE applicables aux appareils radio exempts de licence. L‘exploitation est autorisée aux deux conditions suivantes : (1) l‘appa-
reil ne doit pas produire de brouillage, et (2) l‘utilisateur de l‘appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d‘en compromett-
re le fonctionnement.
RF exposure safety
This device is a radio transmitter and receiver.

It is designed not to exceed the emission limits for exposure to radio frequency (RF) energy set by the ISED. 

The antenna must be installed and operated with minimum distance of 20 cm between the radiator and your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Le modèle est un émetteur et un récepteur radio.

Il est conçu pour ne pas dépasser les limites d‘émission pour l‘exposition à l‘énergie radiofréquence (RF) établie par l‘ISDE.

L’antenne doit être installé de façon à garder une distance minimale de 20 cm entre la source de rayonnements et votre corps.

L’émetteur ne doit pas être colocalisé ni fonctionner conjointement avec à autre antenneou autre émetteur.

CAN ICES-3 (B)/NMB-3(B)
This Class B digital apparatus complies with Canadian ICES-003

Cet appareil numérique de clase B est conforme à la norme Canadienne ICES-003