Operating instructions
Operating instructions
Operating instructions
Operating instructions
Hailo
Hailo
Hailo
Hailo ---- Shaft cover HS
Shaft cover HS
Shaft cover HS
Shaft cover HS8
8
8
8
The operating key # 9515-03 and, if applicable, the key of the profile cylinder in the cylinder lock (optionally)
are required to operate the shaft cover HS8.
1. Unscrew the triangle head cap locking bolt (s) of the locking by means of the operating key and position it at
a clean place (illustration 1)
2. If available, unlock and remove the cylinder lock by means of a key
3. Unscrew the triangle locking nut(s) (illustration 2 and 3)
4. Seize into the opening in the cylinder collar using the hook of the key and lift the cover (illustration 4)
5. The gas-pressurised springs help to open the cover to about 80°, then continue opening the cover manually
until the snib locks in place (illustration 5)
Dated: 21.03.2011
6. Unlock the snib in order to close the cover and perform steps 5 through 1 in reverse order
Illustration 1
Illustration 2
Illustration 3
Illustration 4
Illustration 5
Observe the maintenance and care regulations! (Label on the shaft cover)
Page 5 / 5
Observe the maintenance and care regulations! (Label on the shaft cover)
Dated: 21.03.2011
