hs dock
Technical data
22
Order h49 7144.907-333
3.2 Performance values
NOTE
Material damage to the products use and/or to the
machine tool caused by exceeding the maximum
performance values!
Do not exceed the maximum performance values
[see »General information« chapter].
On all products used, do not exceed the lowest of
the maximum performance values.
Only use product in machine tools with the same
performance values.
INFORMATION
Details of maximum performance values can be found
on each product.
If, due to abrasive wear, those performance values
are no long legible, refer to the operating instructions.
The achievable actuation forces may vary as a result of the
maintenance status [lubrication status and level of contami-
nation] of the product [see »Maintenance schedule« chap-
ter].
3.3 Balancing quality
The product is not balanced ex-factory because it is de-
signed for stationary operation.
3.4 Speed
The product was designed for stationary operation.
WARNING
Serious injuries caused by imbalance during con-
tinuous rotational operation!
Do not operate the product in continuous rotation.
Paying attention to media supply lines, do not ro-
tate the product at more than max. 60 rpm.
From all of the maximum speeds indicated for the
combined products, always remain at the lowest
of those maximum speeds.
