hs dock
Use and limits of use
Order h49 7144.907-333
27
5 Use and limits of use
5.1 Use
The product is there solely to support HAINBUCH clamping
devices on chip-cutting machine tools.
The product can only be used in conjunction with a suitable
clamping device from HAINBUCH.
As well as for its general field of application, this product
was designed and developed for use, when necessary, in a
specific and documented application [see clamping situa-
tion drawing or order confirmation].
Any other fields of application require the explicit approval
of the manufacturer.
5.1.1 Use of the tandem version of the product
The tandem version of the product is used to achieve higher
axial actuating force at a consistent supply pressure.
The tandem version doubles the piston surface area of the
product, and therefore also doubles the axial actuating force.
NOTE
Damage to materials on the products used and/or
to the machine tool caused by exceeding the max-
imum performance values!
Do not exceed the maximum performance values
of the clamping device used.
On all products used, do not exceed the lowest of
the maximum performance values.
Using the tandem version doubles the clamping and release
times.
For the tandem version, the product is needed twice.
The second product is installed on the first product, and is
then connected to the first product using the lateral hydraulic
ports [see »Installation of the tandem version« chapter].
5.2 Aid to selection of the hydraulic unit
The clamping and release times can be relevant to the se-
lection of an appropriate hydraulic unit. The clamping and
release time depends on the volume involved.
