hs dock
Installation
50
Order h49 7144.907-333
DANGER
Serious injuries caused by projectile workpieces
when the hydraulic ports are connected up incor-
rectly!
The hydraulic connections on the machine / the
baseplate and the product must be connected up
correctly.
The »Clamping« hydraulic ports on machine /
baseplate and product must be connected to-
gether. The same applies to the »Release« ports.
WARNING
Serious injuries can be caused by escaping media
when seals and damaged / missing!
Replace missing or damaged sealing elements.
Ensure that the sealing elements do not fall out or
get damaged during installation / removal, and
apply a thin coat of grease if necessary.
8. Connect up the hydraulics. For this the hydraulic ports
on the machine and product must be aligned.
9. Check the position of the product relative to the position
of the test surface [ideally ≤ 0.01 mm] and, if necessary,
correct carefully with a plastic hammer.
10. Tighten down the clamping brackets.
11. Check face run-out on the test surface of the product
[ideally ≤ 0.01 mm].
If the face run-out is greater than the maximum permitted
value:
1. Remove the product.
