ms dock
Installation
Order h49 7144.907-333
37
9. Tighten the product fixing screws to the specified tight-
ening torque [see »Screw tightening torques« chapter].
10. Where required, install the clamping brackets needed on
the product and the machine table.
11. Check face run-out on the test surface of the product
[ideally ≤ 0.01 mm].
Whenever the face run-out is greater than the maximum per-
mitted value:
1. Remove the product.
2. Clean the locating face and the mating faces of the ma-
chine table and the product.
3. If there is a burr or slight damage to the locating face of
the product and the machine table, rub it down gently
with an oil stone.
4. Reinstall the product.
Summary of Contents for ms dock
