ms dock
Maintenance
Order h49 7144.907-333
61
To remove the rocker, turn the actuating screw
clockwise until the actuating screw no longer en-
gages in the thread of the bearing journal. When
turning the actuating screw, guide the rocker in a
parallel manner.
4. Clean all oil and grease residues off all components with
an ester-free, non-polar, soft, lint-free cloth and check
for visible signs of damage.
5. Assemble the product as shown on the exploded draw-
ing. Pay attention to the following during assembly:
Replace worn or damaged fixing screws.
Tighten all fixing screws to the specified tightening
torque [see nomenclature and/or »Screw tightening
torques« chapter]. When tightening the screws, do
so evenly to prevent any distortion under load.
Only apply lubricant to the mechanical mating sur-
faces. Pay attention to notes about lubricants [see
»Use of lubricants« chapter].
Avoid too much lubricant on the locating face be-
cause this can cause face run-out errors.
Apply grease to the sealing elements [for example
O-rings, rectangular rings] and sealing surfaces.
Pay attention to notes about greases [see »Use of
lubricants« chapter].
INFORMATION
The set-up dimension of the housing to the top edge
of the actuating screw measures:
For size XXS-4 / A-F
11𝑚𝑚
For size 5-7:
3𝑚𝑚
Before inserting the rocker in the housing, the actu-
ating screw must be screwed down to its set-up di-
mension in the housing. For this, the set-up dimen-
sion of the housing must be maintained to the top
edge of the actuating screw.
Install the rocker as far as possible in the housing.
To install the rocker deeper, turn the actuating
screw counter-clockwise up to its limit stop. When
turning the actuating screw, guide the rocker in a
parallel manner.
6. Lubricate the product [see »Lubricating the product«
chapter].
7. Check the total stroke of the clamping device [see the
»Checking the total stroke« chapter]
Summary of Contents for ms dock
