TESTit
Measuring device
58
Order h49 7144.907-333
8.5 Setting up the TEST module
Setup of the respective TEST module with measuring
adapter is described in the following.
If the TEST module is to be converted for a different T211
mandrel / for a different zero point clamping system, the
measuring adapter must also be reattached as described be-
low.
8.5.1 TEST module for T211 mandrel
A
Disc
A1 Disc fixing screws
B
Tension bolt
The following steps are necessary to set up the TEST mod-
ule:
INFORMATION
Depending on the version of the measuring adapter, it
may be necessary to screw in the tension bolt before
mounting the disc.
