EN
26
Install the blades by first inserting the rear part. Press the blades with your
thumb to clip them in.
Switch the clippers on for a few seconds after lubricating them.
4
Servicing
4.1
Routine servicing
After using the clippers each time, clean the blades with the brush supplied
(Fig. 1-T).
If necessary, clean the body of the clippers with a cloth slightly dampened with
water or mild liquid soap. Never use abrasive products or solvents.
Clean the blades with an antibacterial spray. We recommend STERIL CLEANER
920- or 921- disinfectant and lubricant products.
Lubricate the blades at least once a day (see § 3.6).
4.2
Cleaning the blades
In the case of regular use, clean the blades at least once a day.
Remove the blades as described in § 3.6.
Clean the inside of the blades with the brush supplied (Fig. 1-T).
With your thumb, press on the 2 lugs (Fig. 8-B) to move the fixed/mobile blades
(Fig. 8-A and 8-C). Eliminate all cutting debris and residues stuck between the
blades (Fig. 8-D).
Lubricate the blades and put back on the clippers as described in § 3.6.
Summary of Contents for TH34
Page 2: ...2 Fig 1 Fig 2...
