Installation
AQUA brings expandable display technology to your bridge or navigation station. A careful
installation will assure maximum benefit from AQUA integrated features.
Display Unit Location
Select a location for your AQUA display unit that provides easy viewing from all likely operator’s
positions. The display unit is designed to be mounted on either a console or from an overhead
surface. The AQUA display is also designed for flush mounting using six threaded holes on the
rear panel. Locate the display in an area with protection from the elements and avoid direct
sunlight on the viewing window. Also, consider access to the rear panel of the unit for
connecting power and cables to the various remote sensors. The mounting surface must be flat
and solid to support the unit and prevent vibration. There should be access to the inside of the
surface to permit through bolt fastening for the mounting bracket.
Display Unit Installation
Temporarily install the mounting bracket on the Genesis display unit and place the unit at the
selected location.
CAUTION
The AQUA display unit is unstable when the mounting bracket is not secured. Hold the unit in
place at all times.
Check the suitability of the location and make any adjustments. When all is satisfactory, use the
holes in the mounting bracket as a guide and mark the holes locations on the mounting surface.
- 58 -
Summary of Contents for AQUA HGP-660
