－14－
4) After completion of 1) ～ 3), pull out clutch adjusting
pin. Hang single-ended wrench 36mm on the main shaft
and then fix the main shaft by making a handle of the
wrench touch the pole. Make sure that the main shaft is
locked. Turn the motor switch on for several seconds and
make sure that the clutch is slipping without motor
locking.
5) After marking sure the clutch is slipping, install hex. plug 1/8” back into the hole.
４． Checking of attaching screws
◎ Check every attaching screws for loosening periodically. If found loose, tighten it.
WARNING
Be careful for the direction of single-ended wrench 36mm marking a hit at pole.
(See the drawing)
