－13－
4) After completion of 1) - 3), pull out Clutch Adjusting Pin.
Hang Single-ended Wrench 36mm on the
Main Shaft
and then stick the main shaft by a handle of the
wrench touching the pole. Make sure that the main
shaft is locked. Turn the motor switch on for just a
moment and make sure that the clutch is slipping
without motor locking.
5) After making sure the clutch is slipping, install Hex. Plug 1/8” back into the hole.
4. Checking of attaching screws
◎
Check every attaching screws for loosening periodically. If found loose, tighten it.
9. FOR REPAIRING
◎
For repairing your machine, contact CONSEC's authorized representative.
10. WARRANTY
We will guarantee the HAKKEN Core Drill SPN-202U
w
for 6 months from the date of delivery.
During this period we will rectify material and production defects free of charge. We are not
responsible for any other damage direct nor indirect other than this. This warranty does not cover
normal wear and tear, overloading, non-compliance with the operating instructions and intervention
by unauthorized persons or the use of parts from other companies.
WARNING
Be careful for the position of Single-ended Wrench 36mm touching on pole.
(See the drawing)
