11 / 40
Hakki Pilke 38 Pro
Translation
Version 3
Place the out-feed conveyor in the transport position as follows:
1.
Turn off the machine.
2.
Release lock D, which holds the upper section of the conveyor in place, and lower the conveyor to the
lowest
possible
position with the winch.
3.
Position support bar B over the belt, and fold the upper section of the conveyor onto the lower section
with handle C.
4.
Turn the conveyor to the middle position. See Section 3.2.4.
5.
Turn splitting groove guard E into transport position, as shown in Figure 9.
6.
Lift the conveyor with the winch until it locks into the raised position. Ensure that lock A connects
firmly.
Note! Do not stand on the out-feed conveyor! Do not use the winch if the rope
is worn!
3.2.
Controls
Figure 10. Controls
Operation of the controls in Figure 10
A.
Out-feed conveyor belt control valve.
- Front position causes the belt to move forward.
- Middle position causes the belt to stop.
- Back position causes the belt to move backward.
