15 / 40
Hakki Pilke 38 Pro
Translation
Version 3
3.2.3.
Adjusting the log length
The Hakki Pilke 38 Pro is equipped with a mechanical log measurement device with an incremented
adjustment value of 22–60 cm.
1.
Turn the machine off and open the
machine’s guard.
2.
When the wood limiter is in the
splitting position, set it to the
desired length by removing cotter
pin B in the limiter's locking pin
and by pulling out locking pin A.
Lock limiter plate C in the desired
position. Re-insert locking pin A
and cotter pin B.
Note! Turn the limiter plate to the
correct position according to the
thickness of the log. (See Figures 17
and 18). The wrong position may
cause damage to the machine!
Figure 17. Limiter plate position for large
logs of more than 25 cm in diameter
Figure 16. Log length adjustment
Figure 18. The limiter plate position for small logs
3.2.4.
Using the out-feed conveyor
The Hakki Pilke 38 Pro firewood processor’s out-feed conveyor belt is driven by a hydraulic motor. To change
the speed of the belt, use adjuster B (Figure 10). The following describes how the conveyor can be turned
laterally by using turning lever A and handle B:
