2 / 40
Hakki Pilke 38 Pro
Translation
Version 3
Table of contents
1.
General information ..................................................................................................................... 4
1.1.
Introduction .............................................................................................................................................. 4
1.2.
Purpose of use .......................................................................................................................................... 4
1.3.
Machine models and basic information ................................................................................................... 4
1.4.
Operating conditions ................................................................................................................................ 4
1.5.
Safety instructions .................................................................................................................................... 5
1.6.
Noise and vibration .................................................................................................................................. 5
1.7.
Warning symbols ...................................................................................................................................... 5
2.
Receipt and assembly................................................................................................................... 7
2.1.
Delivery inspection ................................................................................................................................... 7
2.2.
Lifting and moving the machine ............................................................................................................... 7
2.3.
Main components of the machine ........................................................................................................... 8
2.4.
Preparing the machine for operation .........................................
Virhe. Kirjanmerkkiä ei ole määritetty.
3.
Control functions and setting up the machine ............................................................................ 9
3.1.
Arranging the machine for operation and transport ............................................................................... 9
3.1.1.
Placing the in-feed conveyor in the operating or transport position ............................................... 9
3.1.2.
Placing the out-feed conveyor in the operating or transport position .......................................... 10
3.2.
Controls .................................................................................................................................................. 11
3.2.1.
Tractor drive .................................................................................................................................... 12
3.2.2.
Electrical drive ................................................................................................................................. 13
3.2.3.
Adjusting the log length .................................................................................................................. 15
3.2.4.
Using the out-feed conveyor .......................................................................................................... 15
3.2.5.
Splitting blade adjustment .............................................................................................................. 17
3.2.6.
Using a sawdust removal device ..................................................................................................... 17
4.
Operating the machine .............................................................................................................. 17
4.1.
Performing a test run on the machine ................................................................................................... 17
4.2.
Placing logs on the in-feed conveyor ..................................................................................................... 18
4.3.
Feeding and sawing wood ...................................................................................................................... 18
4.3.1.
Jamming of the cutting blade ......................................................................................................... 19
4.3.2.
Sawing the last log .......................................................................................................................... 19
4.3.3.
Using the quick couplings of the additional hydraulics .................................................................. 19
4.3.4.
Using the quick couplings of the auxiliary feed rollers ................................................................... 19
4.4.
Log splitting ............................................................................................................................................ 20
4.4.1.
Jamming of wood on the splitting blade ......................................................................................... 20
