24 / 40
Hakki Pilke 38 Pro
Translation
Version 3
B (in Figure 26a).
Note! The operator must ensure that the distance between the debris discharge opening and the pile of
debris that accumulates under it is at least 20 cm.
4.6.
After use
1.
After you have finished making firewood, stop the out-feed conveyor, shut down the machine and
remove the firewood from the splitting channel and conveyor.
2.
Check that the machine has not been damaged.
3.
Place the out-feed conveyor into a position that allows the conveyor and firewood processor to be
moved safely off the processed firewood.
4.
Clean the machine.
If you will not be using the firewood processor for a while, do the following:
5.
As necessary, use your tractor's hydraulics or a forklift to hoist the firewood processor and carefully
move it to a location where you can place the in-feed and out-feed conveyors as well as the working
platform into their transport and storage positions.
6.
Place the conveyors into the transport and storage position.
7.
Clean the machine and carry out any maintenance.
8.
Store the machine according to the instructions in Section 6.
5.
Machine maintenance
The machine must be disconnected from its power source before any maintenance, adjustment, replacement
or cleaning measures. Only use spare parts that are supplied by the manufacturer or your retailer. If any
guards of the machine have to be removed for maintenance, they must always be reattached before the
machine is activated. After maintenance and adjustment measures, a test run must be carried out on the
machine, according to the instructions in Section 4.1.
5.1.
Cutting blade and drive end
If the cutting blade of the machine does not penetrate the wood properly, cuts it too slowly or the cut is
skewed, the saw chain is most likely blunt. It is a good idea to keep a replacement chain on hand, so that you
do not need to interrupt your work to sharpen the chain.
