27 / 40
Hakki Pilke 38 Pro
Translation
Version 3
5.2.
Changing the multiplier gear’s oil
1.
Remove the rear cover of the machine in
accordance with the instructions in steps 1–
5 in Section 5.3.
2.
Open filler cap A (this will allow the oil to
drain more easily) and drain cap C and the
drain the oil into a suitable container.
3.
Close drain cap C and open inspection cap
B.
4.
Add appropriate oil into the multiplier gear
through filling hole A, until the oil surface is
level with inspection hole B. Approx. 0,5
liters.
5.
Finally, also close caps A and B, and re-
install the rear cover of the machine in the
reverse order of steps 1–5 in Section 5.3.
Figure 29.
5.3.
Changing the oil
Change the hydraulic oil of the firewood
processor as follows:
Note!
Select the appropriate oil type according to
the type of operation and outdoor temperature. If
the electric motor is started at sub-zero
temperatures, we recommend using an oil with ISO
VG 32 viscosity, maximum oil temperature of
60 °C. In warmer environments, we recommend a
viscosity of
ISO VG 46, maximum oil temperature
of 75 °C.
1.
Shut the machine down and disconnect it
from its power sources.
2.
Remove the rear cover of the machine in
accordance with the instructions in steps 1–
5 in Section 5.2.
3.
Open filler cap A of the hydraulic oil tank
(this will allow the oil to drain more easily).
Figure 30.
