29 / 40
Hakki Pilke 38 Pro
Translation
Version 3
5.4.
Conveyor maintenance
5.4.1.
Replacing and tensioning the in-feed conveyor belt
Replace the in-feed conveyor belt as
follows:
1.
Shut the machine down and
disconnect it from its power
sources.
2.
Raise and lock the in-feed
conveyor into the transport
position. (See Section 3.1.1.)
3.
Move the belt joint to a suitable
height.
4.
Disconnect the joint by using, for
example, pliers to pull out pin A,
which holds the joint together.
5.
Remove the old belt.
6.
Slide the new belt under the
table from the side of the in-feed
conveyor's drive roller B until you
can pull the belt out from the
other end C.
7.
Lead the rest of the belt under
the wood gripper, around the
rear roller and, finally, behind the
conveyor.
8.
Connect the joint by inserting pin
A into the joint.
9.
Turn the conveyor back to the
operating position and tension
the belt.
10.
Finally, adjust the belt to the
correct tension and to run
straight with the help of the
adjustment nuts D.
The belt is at the correct tension
when its middle section is raised
approx. 5 cm when the conveyor
is in the operating position. An
excessively tight belt may be
damaged more easily, and it
places unnecessary strain on the
conveyor bearings.
Figure 34.
Figure 35. Figure 36.
Figure 37.
