9 / 40
Hakki Pilke 38 Pro
Translation
Version 3
3.
Control functions and setting up the machine
3.1.
Arranging the machine for operation and transport
Before arranging the machine for operation and using it, ensure that the operating conditions, detailed in
Section 1.4, are met and review the safety instructions in Section 1.5.
Note! Inspect and clean the machine before rearranging the machine.
3.1.1.
Placing the in-feed conveyor in the operating or transport position
Place the in-feed conveyor in the operating
position as follows:
1.
Ensure that sufficient room is
available to lower the input
conveyor (approx. 2 m).
2.
Release the lock by lifting handle
A upward with your left hand.
Note! At the same time, hold the
end of the input conveyor with
your right hand!
3.
Lower the input conveyor down
with your right hand and, at the
same time, use your left hand to
guide support leg C into slots B, as
instructed in Figure 4.
When placing the input conveyor in the
transport position, lift the conveyor to the
upper position and ensure that locking
latch A locks the conveyor, i.e. that lock A
is inserted in the slot circled in Figure 3.
Figure 3.
Figure 4.
