25 / 47
Hakki Pilke 50 Pro
Translation
Version 1-2018
4.4.
Log splitting
4.4.1.
Jamming of wood on the splitting blade
If a piece of wood gets jammed on the splitting blade in a situation where the splitting force is insufficient
to push the piece past the blade, carry out the following:
1.
Return the splitting beam fully to the starting position by pressing
button A (Figure 11)
.
2.
Restart the splitting by pressing button C (Figure 11). This recharges the machine’s pressure
booster to provide full power.
3.
If the log is still not split completely, raise the splitting blade slightly (approx. 5 cm) and repeat
step 2.
4.4.2.
Resplitting or splitting without cutting
1.
Raise the protective cover of the cutting and splitting groove.
2.
Place the log you want to split in the splitting groove.
3.
Close the protective cover of the cutting and splitting groove.
4.
Activate the splitting cycle with button C (Figure 11).
The above procedure can be used to split wood without cutting it, as necessary.
4.4.1.
Replacing the splitting blade
Exercise extreme caution when handling the blade, and wear protective gloves.
1.
Pull handle B (Figure 20).
If the handle does not
move, raise the blade
slightly.
2.
Lower the splitting blade
to the lowest possible
position to remove the
control shaft from slot A
(Figure 20).
If
necessary,
remove
pieces of wood from
under the blade.
3.
Turn off the machine and
disconnect it from the
power source.
Figure 20.
