20 (39)
Hakki Pilke 27
Original
Version 5-2014
Test Run
A test run must always be carried out before putting the machine into operation.
1. Make sure that the conveyor is in the work position and that the splitting chute
cover is down.
2. Start the tractor and let the engine idle.
3. Start the rotation of the tractor's power take-off by lifting the clutch pedal slowly
and smoothly. Let the machine run for a while.
4. For an
electrically driven
machine, let the machine run for a few minutes
depending on air temperature
to warm up the oils before starting the test run.
5. Bring the splitting control lever to the
In operation
position.
6. Start the splitting movement with the pedal. Repeat the movement several times
and check that the machine is operating normally. Should there be any faults, repair
them.
7. Test the functions described in section
Operation and Control of a Hydraulic
Splitting System
.
If the functions are working correctly, you can start processing firewood as
instructed below.
Before Processing Firewood
Do not begin to process firewood until you are fully familiar with the operating
principle of the machine and the safety precautions.
When processing firewood, you should:
- wear safe clothes:
- an outfit suitable for the weather conditions, with no hanging parts or
strings that may get caught in the wood or the machine and thus cause an
accident;
- safety boots with non-slip soles;
- gloves that give you a firm hold of the wood;
- appropriate face and eye shields and hearing protectors;
- arrange the work site so that:
- it is even and there is enough space for working;
- the trees are at an appropriate distance from the machine;
- familiarise yourself with safe working practices.
