PREPARATION: ASSEMBLY AND ELECTRICAL CONNECTION
Preparation: Assembly and Electrical Connection
A. Station Assembly
●
Attach the handpiece holder.
Remove the handpiece holder mounting screw
from the side of the station. Attach the
handpiece holder to the station. (Figure 1)
(The handpiece holder can be installed on
either the left or right side.)
B. Handpiece Assembly
●
Attach the nozzle.
Loosen the nozzle mounting screw. Attach the
nozzle as shown in the drawing.
(Figure 2)
C. Electrical Connection and
Power ON
1. Place the handpiece on the holder. (Figure
4)
2. Plug the power cord into a grounded wall
socket.
3. Turn the power switch ON.
Tighten the nozzle
mounting screw.
(Figure 1)
(Figure 2)
(Figure 3)
Inside screw
When installing an optional
nozzle to the Hakko 850D, do
not remove this inside screw.
CAUTION
This product is ESD-protected. Be sure to use a grounded
wall socket.
(Figure 4)
CAUTION
When not in use, place the
handpiece on the holder.
S
4
