The tip may be hot. Avoid holding the hot tip for a long time even if
using the heat-resistant pad. Otherwise burns may result.
CAUTION
Removing the tip:
●
Hold down the lock release buttons in the sleeve assembly, pull out
the tip together with the sleeve assembly from the connector.
●
While holding the front end of the sleeve assembly, pull out the tip.
• Be sure to keep the lock release buttons held down while pulling
out the sleeve assembly. Failure to do so will damage the locking
mechanism.
• Be sure to pull out the tip only after separating the sleeve assembly
from the connector. Otherwise, the sleeve assembly may fall down
and break.
CAUTION
Insert the tip:
●
Reassemble in the reverse order of disassembly.
• Insert the tip into the sleeve assembly until it clicks into place. When
you hear it click, avoid forcing the tip into the sleeve assembly.
• When holding the head of the tip, there is a danger of burn. Be sure
to use the heat-resistant pad.
CAUTION
*Each Hakko handpiece with the exception of the HAKKO
FM-2027 has their own instruction manual. Please refer to
this manual for specifications and replacement parts.
■
Switch, Control Button and Knob Usage
Power switch
Use the power switch to turn
the power on and off.
Control Buttons
Use to change settings such as
temperature.
When pressed briefly:
Displays the preset screen.
When pressed and held:
Displays the change settings
screen.
Change Settings Screen Details
1. Temperature Settings
2. Offset Settings
3. Preset Temperature Settings
4. Preset Names
5. Channel Power (On/Off)
6 Exit
Control Knob Usage
Use to change settings
Turning the control knob:
Changes setting values
or moves the cursor
Pushing the control knob:
Makes selection
* If you press a control button while on the Preset or Change
Settings screen, the corresponding channel screen will be
displayed.
Plugged in irons will be heated according to the settings
when the power is turned on.
Flow Control Knob
When HAKKO FM-2029 is connected to
HAKKO FM-206, air flow will be displayed.
By turning the flow control knob, air flow
can be changed.
CH1
CH2
CH3
350
℃
Off
Ready
SOL
100%
M
●
Replacing the tip (HAKKO FM-2027)
4. INITIAL SETUP
3
Summary of Contents for fm-206
Page 17: ......
