Hakko Electronics fm-206, Instruction Manual

Parameter name
AutoSleep
Sleep Temp

Low Temp
Error Alarm
Ready Alarm
Pump Select*
Exit

Initial value
6min

200℃ (390℉

)

150℃ (270℉

)

On
On
Internal

Channel parameters

Value

OFF / 0 ~ 29min
200 ~ 300℃ increments of 20℃
(390 ~ 570℉ increments of 36℉

)

30 ~ 150℃ (54 ~ 270°

Ｆ

)

On / Off
On / Off

Internal / External

Explanation of each parameter and how to change the settings

●

 Temperature Mode

The displayed temperature can be switched between Centigrade and Fahrenheit. Turn the control knob 

to switch it and press the control knob when you have made your choice.

Temperature Mode

℃

°F

Select

Execute

●

 Auto-Shut Off Setting

Select whether you will activate the auto shut off function. You can select from three options: OFF, 30 

minutes or 60 minutes. Turn the control knob when making your selection and press the control knob 

when you have made your choice.

Auto-ShutOff

Setting

Off

30min 60min

■

 Parameter settings

For parameters, there are two types: system parameters and channel parameters. System parameters are used 

for the settings for the entire system, and channel parameters are used for the settings for each channel. 

The 

change parameters screen can be displayed by turning on the power while the control knob is pressed.

6. PARAMETER SETTINGS

P a r a m e t e r

S y s t e m

C h a n n e l

E x i t

Parameter name
Temp Mode

Auto-Shut Off

Vaccum Mode
Vacuum Time*

Password Lock

Password**
Initial Reset

Initial value

℃
Off

Normal
1sec
OFF
none

System parameters

Value

℃ / ℉
Off / 30min / 60min

Normal / Timer
1

〜

5sec

ON / Partial / OFF

3 upper case alphabetic characters

OK / Cancel

* 

 "Vacuum Time" is displayed when "Timer" is selected in Vacuum Mode.

** "Password" is displayed when "ON" or "Partial" is selected for the Password Lock.

S y s t e m

Te m p   M o d e

S h u t O f f   S e t

Va c u u m   M o d e

Va c u u m   T i m e *

P a s s w o r d L o c k

P a s s w o r d * *

I n i t i a l R e s e t

E x i t

℃

O f f

T i m e

1 s

O n

System setting screen

●

 Vacuum Mode Setting

Suction with the desoldering iron is performed either manually or in timer form. For mode selection, turn the 

control knob and press the control knob when you have made your choice.

Vacuum Mode

Setting

Normal

Timer

●

 Vacuum Time

This item is displayed when selecting "Timer" in Vacuum Mode. After suction, you can set the amount of 

time it will operate after you remove your hand from the trigger. When changing the numerical value, turn 

the control knob; Press the control knob to accept your selected value.

Change numerical 

value

Accept

Vacuum Time

Setting

1

sec

Normal

Timer

: suction only when the trigger is pulled

: suction performed for a designated time* 

even after you remove your hand from 

the trigger

* Time setting is set as "Vacuum Time".

*  "Pump Select" is displayed when a hot air 

handpiece is connected to channel 3.

Select

Execute

Select

Execute

9