11
Component Nest:
Note: The component nest and optics train are shown in their
retracted positions. The component nest (1) and optics train
(4) must be fully retracted for the head to be lowered to the
DOWN position.
Figure 19: Component Nest
The component nest (1) is provided for
aligning a component to the heater
nozzle, and for receiving a hot
component after it has been removed
from the board. The system is furnished
with a generic plate (not shown) which
fits into the component nest to aid in
aligning new components with the
heater nozzle (5). Component Print
Frames, or CPF (2), also fit into the
component nest, and are available for
stencil printing solder paste onto BGA
(3) and some other SMT components.
With the head UP, extend the
component nest to its right-most
position to align the center of the nest
insert (2) with the nozzle (5) for
receiving hot components, or
transferring a new component to the
nozzle.
Rear Panel:
Figure 20: Rear Panel
Item
Description
Item
Description
1
Rear Panel
5
Serial Number Decal
2
On/Off Switch (Power Switch)
6
Host PC and/or Options Connector(s)
3
Air/N2 Supply Inlet (1/4” Tubing)
7
Power Cord
4
Services to Head Assembly
1
2
3
4
5
2
7
5
6
3
1
4
