12
2.0 Unpacking and Installation:
The rework system packaging may vary due to the specific model purchased, options installed, and
shipping/transportation requirements. The following figures provide a general guide for unpacking the
system.
Figure 21: Outer cardboard or crating removed
Figure 22: Bracing and Plastic Removed
To unpack the machine:
Remove the outer cardboard or wooden crating material. Remove the two 5/16 lag bolts (2), and the
hold-down brace (1) from the cushioned skid (4). Remove the outer plastic sheeting, shrink wrap or
optional vapor-barrier bag (3). Remove the nozzle kit (5), accessory pack (6), and any LCD monitor (7)
and/or optional equipment. The machine can now be lifted off the skid using at least two people. The
uncrated machine weighs approximately 140 pounds. Place the machine on a stable bench with a solid
top. The bench should not wobble or bend under the weight of the machine. If necessary adjust the four
leveling feet so that the machine sits flat on the bench without rocking. Remove any final shrink wrap,
plastic or foam, except the foam block (8) under the head. Raise the head to remove the final foam
block. Remove the cardboard (9) covering the bottom heater.
2
2
1
3
5
7
6
4
8
9
Figures 22 & 23: Axes Blocked
Stop Collars (1) are used to
secure the axes for shipment.
Loosen the #10-32 set screws
and slide the collars out of the
way.
1
1
1
1
Y-Axis
X-Axis