3
Loosen the adjusting screws to change the angle
of the handpiece receptacle as you like, then tighten
the screws.
4. INITIAL SETUP
A. Handpiece holder
First, remove any excess solder from the nozzle by
thrusting the nozzle into the cleaning wire. (Do not wipe
the nozzle against the wire. This may cause molten
solder to spatter.)
●
Operation
Following the instructions given in the illustration
on the right, assemble the handpiece holder.
1. Insert the holder assembly securely into the handpiece
holder base.
2. When the cleaning wire becomes dirty or loaded with
solder, turn the wire until a clean surface is presented.
3. When changing the cleaning wire, lift the top vertically
to prevent solder debris from falling out.
CAUTION
Do not set up the angle of the handpiece receptacle too high, or
the temperature of the handpiece will become very hot.
B. HAKKO FR-4001
●
Replacing the filter
Replace the filter as shown following steps
A to C. During operation, the filter pipe is
very hot. Wait until the filter pipe is cool
before replacing the filter or cleaning.
We recommend keeping a second filter
pipe containing new filters handy, and
replacing the installed filter pipe with this
secondary filter pipe.
B. Pull
A. Down
C. Replace the entire filter pipe with
a secondary filter pipe.
