15
11. PART NAMES (Desoldering Tool)
SOLDER
DESOLDER
UP
Clogging
Indicator
DOWN
ENTER
POWER
FR-701
UP
ENTER
Soldering
Desoldering
●
Station
Power Switch (Main)
Receptacle
(Desoldering Tool)
Vacuum
outlet cap
Power Switch (Desoldering Tool)
Control Buttons
(Desoldering Tool)
●
Handpiece (HAKKO FR-4103 Desoldering Tool)
Nozzle
Back holder
assembly
Release knob
Hose
Filter pipe
Trigger
Heating element
(Inside)
Cord assembly
16
12. INITIAL SETUP (Desoldering Tool)
A. Iron holder
CAUTION
Increasing the angle of the handpiece receptacle will
cause an increase in the handpiece temperature.
NOTE :
You can put nozzles that are not in use on the radial tray
of the cleaner base.
Loosen the adjusting screws to change the angle of the handpiece
receptacle as you like, then tighten the screws.
●
Setup the iron holder
Following the instructions given in the illustration on the right,
assemble the iron holder.
Radial tray
●
When the cleaning sponge is included in the PACKING LIST
The sponge is compressed. It will swell when moistened
with water. Before using the unit, dampen the sponge with
water and squeeze it to remove excess water.
CAUTION
Be sure the sponge is moistened with water before use to avoid damaging the nozzle.
1. Fit the small sponge pieces into the hollows in the
cleaner base.
2. Add an appropriate amount of water into the cleaner base.
The small sponge pieces will absorb water and help keep
the larger sponge damp at all times.
3. Dampen the large sponge, squeeze it to remove excess
water and put it on the cleaner base.
●
When the cleaning wire is included in the PACKING LIST
Following the instructions given in the illustration on the right,
put the cleaning wire on the cleaner base.
Operation:
First, remove any excess solder from the nozzle by thrusting
the nozzle into the cleaning wire.
(Do not wipe the nozzle against the wire. This may cause
molten solder to spatter.)
When the wire becomes dirty or loaded with solder, reposition
the wire until a clean surface is presented. When changing the
cleaning wire, lift the case top vertically to prevent solder debris
from falling out.
Cleaning wire
Cleaning
sponge
(Large)
(Small)
Cleaner base