1
1. PACKING LIST
Please check to make sure that all items
listed below are included in the package.
HAKKO FR-4103 handpiece
with N61-05 (ø1.0 mm [0.04 in] type S) nozzle
HAKKO FH-410 iron holder
Tool box
Instruction manual
HAKKO FR-701 station
Power cord
HAKKO FX-8801 soldering iron
with cleaning sponge
HAKKO FH-800 iron holder
Cleaning wire
1
1
1
1
1
1
1
1
1
HAKKO FR-701
HAKKO FH-800
Cleaning wire
Power cord
Cleaning Pin
(for ø1.0mm nozzle)
Nozzle wrench
Tool box
×1
Cleaning Pin
(for heating element)
×1
Cleaning Drill
(for ø1.0mm nozzle)
×1
Ceramic paper
Filter
(for handpiece)
Filter
(for station)
×2
×4
×1
HAKKO FX-8801
HAKKO FR-4103
HAKKO FH-410
or
Cleaning wire
Cleaning sponge
2
2. SPECIFICATIONS
●
Handpiece (Desodering tool HAKKO FR-4103)
Power consumption
Nozzle to ground resistance
Nozzle to ground potential
Cord length
Length (w/o cord)
Weight (w/o cord)
140 W (24 V)
<2 Ω
<2 mV
1.2 m (3.9 ft.)
168 mm with N61-05 nozzle
190 g with N61-05 nozzle
65 W (26 V)
<2 Ω
<2 mV
Ceramic heater
1.2 m (3.9 ft.)
217 mm (8.5 in.) with B tip
46 g (0.10 lb.) with B tip
Power consumption 260 W
* The temperature was measured using the FG-101 Soldering Tester.
* This product is protected against electrostatic discharge.
* Specifications and design are subject to change without notice.
●
Handpiece (Soldering iron HAKKO FX-8801)
Power consumption
Tip to ground resistance
Tip to ground potential
Heating element
Cord length
Total length (w/o cord)
Weight (w/o cord)
●
Station (Soldering iron)
Output
Temperature range
Temperature stability
AC 26 V
50 - 480℃ (120 - 899℉)
±1℃ (±1.8℉) at idle temperature
When set to 200 - 480℃ (400 - 899℉)
●
Station (Desoldering tool)
Output
Vacuum generator
Vacuum pressure (max.)
Suction flow
Temperature range
Temperature stability
AC 24 V
Vacuum pump, double cylinder type
80 kPa (600 mmHg)
15 L/min.
330 - 450℃ (620 - 850℉)
±5℃ (
±
9℉) at idle temperature
●
Station
●
HAKKO FR-701
Dimensions (W × H × D)
Weight
190 (W) × 140 (H) × 220 (D) mm
(7.5 × 5.5 × 8.7 in.)
6.2 kg (13.7 lb.)
■
Electrostatic Protection
This product includes such features as electrically conductive plastic parts and grounding of the unit
as measures to protect the device to be soldered from the effects of static electricity. Be sure to observe
the following instructions:
1. The plastic parts are not insulators, they are conductors. When making repairs or replacing parts,
take sufficient care not to expose live electrical parts or damage insulation materials.
2. Be sure to ground the unit during use.
CAUTION
