13
E. File changing method in AUTO mode
CAUTION
Be sure to insert the control card into the card slot
before changing.
File initial setting
File 1
File 2
File 3
Mode
INSTALL
INSTALL
INSTALL
Step 1
Setting temperature
200
200
200
timer time
30
30
30
Step 2
Setting temperature
250
250
250
timer time
30
30
30
Step 3
Setting temperature
300
300
300
timer time
30
30
30
Example: When file 2 is changed as follows:
File 2
Mode
REMOVE
Step 1
Setting temperature
250
timer time
25
Step 2
Setting temperature
250
timer time
30
Step 3
Setting temperature
320
timer time
25
1. If the
button is pressed for 1 second
or more, the file number display section
flashes. Select the file number using the
or
button. If your desired file number is
displayed, press the
button. The mode
will be shifted to
the INSTALL or REMOVE
selection mode
.
2. Use the
or
button to display
.
Then, press the
button to select and shift
to
the step selection mode
.
3. Select your desired step using the
or
button. Display your desired step and press
the
button to select. After that, the mode
will be shifted to
temperature setting mode
in step 1
.
6. OPERATION
Press the
or
button.
Press the
button.
Press and hold the
button
for more than 1 second.
NOTE:
The temperature setting range:
100°C - 450°C (200°F - 840°F).
The time setting range:
0 sec. - 300 sec. (0 min. - 5 min.)
●
Attempt to enter a value outside the setting
range will cause the display to begin flashing the
HUNDREDS digit again. Reenter a correct value.
●
Both the display temperature and the
temperature setting are the temperature at the
sensor. (Even with the same temperature setting,
the temperature of the hot air differs depending
on the nozzle size.)
●
If the time setting is set to 0 sec., the step can be
cancelled.
Press the
or
button.
Press the
button.
Press the
button.
