4
CAUTION
If the measurement unit is lower than the temperature
of the internal station, you will see the temperature
inside the station is on the monitor.
NOTE
:
・
A ø0.1mm thermocouple (B5127) is sold separately. It can be used for measuring the temperature in
gaps, etc. into which the ø0.2mm thermocouple cannot fit.
・
Heat-resistant tape (B5130; 100 strips) is sold separately. It can be used for attaching a thermocouple
to a part.
⑦
⑥
③
S (START/STOP) button
・
MANUAL mode
Pressing this button once starts the blowing of hot air.
Pressing this button again starts cooling down, and when the temperature has reached 100°C or
90 seconds since the start of cooling has passed, the blowing of air is automatically stopped.
・
AUTO mode
Pressing this button once starts the program.
Pressing this button again starts cooling down, and when the temperature has reached 100°C or
90 seconds since the start of cooling has passed, the blowing of air is automatically stopped.
④
V (VACUUM) button
Pressing this button switches the vacuum pump ON and OFF.
⑤
T/C connector (Labeled with "P"; for parts)
Insert the thermocouple in the thermocouple connector;
then, bring the tip of the thermocouple into contact with
any location where you want to take measurements.
When selecting the “Part” (refer to the “Sensor selection”
in page 11), HAKKO FR-811 can make control from part temperature during the measurement.
⑦
USB I/F terminal
A USB cable can be plugged into this terminal for connection with a PC.
By connecting the HAKKO FR-811 to a PC, the PC can be used for
performing settings or for storing or reading data.
(refer to the “7. CONNECTION WITH PC” in page 19)
⑥
USB device terminal
A USB memory device can be plugged into this terminal and data can
be stored onto the device, read from the device, etc.
CAUTION
・
When using a USB memory device, be careful of static electricity.
・
When using a USB memory device, be careful not to bump the device
against objects or drop the device.
CAUTION
USB memory and a USB cable can not be used at the same time.
Summary of Contents for FR-811
Page 47: ...46 MEMO...