Hakko Electronics FT802-03, Instruction Manual

8

①

Hold the       and       buttons pressed while switching on the power to enter parameter input mode.

（   ➡   ）➡   ➡（   ）➡   ➡（   ）

Parameter input mode flowchart
Follow the steps below to input parameter values.

After setting the required parameter values, press and hold the [ENTER] button while 

performing operations in Step 2 to 3.

④

The display will change to            and the unit will ask you whether to exit the parameter input 

mode. Selecting            and pressing the [ENTER] button will exit the parameter input mode.

You can switch the display between            and            by pressing the       or 

     button. When selecting         , the current screen will be jumped to the 

parameter number selection screen 

②

 again.

NOTE:

②

Select the parameter number.

Initially, the parameter number            will be blinking. Change the parameter number to  

the parameter to be set by pressing the       or       button.

Pressing the       button causes the number to be displayed in the following order:

Pressing the       button displays the number in reverse order.

Selecting the parameter number and pressing the [ENTER] button changes the display to  

the parameter value.

③

Select the parameter value.

The currently-set value is displayed initially. Change to the desired parameter value by 

pressing the       or       button. Pressing the [ENTER] button returns to the parameter number 

selection mode.

6. SETTING PARAMETERS (continued)

6-2 Parameter setting procedure