2. SPECIFICATIONS
3. WARNINGS, CAUTIONS AND NOTES
AC26V 65W
< 2 Ω
< 2 mV
Ceramic heater
1.2 m (3.9 ft.)
217 mm (8.5 in.) with B tip
46 g (0.10 lb.) with B tip
Power consumption 135W
* The temperature was measured using the FG-100 thermometer. * This product is protected against electrostatic discharge.
* Specifications and design are subject to change without notice.
●
HAKKO FX-8801 Soldering iron
Power consumption
Tip to ground resistance
Tip to ground potential
Heating element
Cord
Total length (w/o cord)
Weight (w/o cord)
●
Station
Output
Temperature range
Temperature stability
Dimensions (W × H × D)
Weight (w/o cord)
AC26V
50 - 480℃ (120 - 899℉)
±1℃ (±1.8℉) at idle temperature
{When set to 200-480℃ (400-899℉)}
157(W) × 121(H) × 149(D) mm
(6.2 × 4.8 × 5.9 in.)
2.1 kg (4.6 lb.)
■
Electrostatic Protection
This product includes such features as electrically conductive plastic parts and grounding of the unit
as measures to protect the device to be soldered from the effects of static electricity. Be sure to observe
the following instructions:
1. The plastic parts are not insulators, they are conductors. When making repairs or replacing parts,
take sufficient care not to expose live electrical parts or damage insulation materials.
2. Be sure to ground the unit during use.
Warnings, cautions and notes are placed at critical points in this manual to direct the operator’s
attention to significant items. They are defined as follows:
WARNING
WARNING: Failure to comply with a WARNING may result in serious injury or death.
CAUTION: Failure to comply with a CAUTION may result in injury to the operator, or damage to the
items involved.
To prevent accidents or damage to the HAKKO FX-889, be sure to observe the following:
●
Do not use the HAKKO FX-889 for applications other than soldering.
●
Do not strike the iron against hard objects to remove excess solder. This will damage the iron.
●
Do not modify the HAKKO FX-889.
●
Use only genuine HAKKO replacement parts.
●
Do not allow the HAKKO FX-889 to become wet, or use it with wet hands.
●
Remove power and iron cords by holding the plug, not the wires.
●
Be sure the work area is well ventilated. Soldering produces smoke.
●
While using the HAKKO FX-889, don’t do anything which may cause bodily harm or physical damage.
When power is ON, tip temperatures will be between 50 and 480℃. (120 to 899℉)
To avoid injury or damage to personnel and items in the work area, observe the
following:
●
Do not touch the tip or the metal parts near the tip.
●
Do not allow the tip to come close to, or touch, flammable materials.
●
Inform others in the area that the unit is hot and should not be touched.
●
Turn the power off when not in use, or left unattended.
●
Turn the power off when changing parts or storing the HAKKO FX-889.
●
This unit is for counter or workbench use only.
●
This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in safe way and understand the hazards
involved.
●
Children shall not play with the appliance.
●
Cleaning and user maintenance shall not be made by children without
supervision.
